Water flows into the InvisiHead. Super slow approach and entrance velocities insure low level 
loss and minimum sediment flowing into the intake basin onshore

The InvisiHead works as an outfall. Heat and effluent dispersion and dilution 
takes place at the immediate vicinity of the InvisiHead.

Elmosa is phasing in HDPE pipe and phasing out steel and concrete where applicable.

The NatSep is designed to separate any sediment that may flow through into the basin as part of the water flowing into the InvisiHead. By the time the flow reaches
the seawater pump bay it is free of sand and weeds.

The InvisiHead receives the water capacities through for consecutive phases: The approach where the hydraulic invisibility takes place, the Stabilization self cleaning is activated through the submarine currents, the Acceleration where smooth transfer of flow takes place, and the Steady where the flow regime assumes final conditions.

Posters: 338 kB, 520 kB, 1,831 kB, 2,785 kB

Elmosa Offshore Seawater Intake System: A combination of environment, science, and technology. Low initial investment,  minimum operation and maintenance costs.

Elmosa Onshore Intake System, the Infiltration. Water is filtered at the source. Self operation and maintaining. Low initial investment and very low operation and maintenance costs if any. The Infiltration is the ultimate in water intaking.

The following images demonstrate our capabilities and ability to handle any seawater intake system or outfall.

Copyright © 1998-2009 ELMOSA. All rights reserved